General Technical & Electrical General technical and electrical discussion for the Ford Ranger that does not fit in any other sub-forum.

Alarm Issues - Possible Door Lock problems?

Thread Tools
 
Search this Thread
 
  #1  
Old 01-13-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
Alarm Issues - Possible Door Lock problems?

background info: aftermarket alarm system w/ keyless entry via key fob.

symptoms: when the alarm is set, it will (seemingly) randomly go off at all times during the day. which really annoys my roommates in the middle of the night.

Steps taken already: Removed the 'shock sensor' thingie. checked the grounds i could easily find.

My thinking: I've heard tell that our door lock sensors/switches like to go bad from time to time. so im thinking that if something connected to my door locks is on its way out and is telling my alarm system that my door is being opened...my problem is the door locks.

What do you guys think? I wanted to get some input before i begin tearing into my door panels or anything like that.

Also, if you do think its the locks, whats the difficulty rating & cost of replacing them?

Thanks fellas.
 
  #2  
Old 01-14-2008
Rev's Avatar
Rev
Rev is offline
Member
Join Date: May 2005
Location: San Diego, CA
Posts: 1,179
Likes: 0
Received 7 Likes on 6 Posts
Did this just start recently or has it been doing this since it was installed?
Does it go off about every 45 mins or so?
Have you noticed the dome light staying on or the door ajar light on after you get in and close the door?

.
 

Last edited by Rev; 01-14-2008 at 01:32 AM.
  #3  
Old 01-14-2008
thef9est1's Avatar
Member
Join Date: May 2007
Location: OLY, Washington
Posts: 536
Likes: 0
Received 0 Likes on 0 Posts
No I had this problem too...all it is is your holding down the panic button in your pocket...if the panic button is held for 3 sec it will just go off...my bet that is what your doing too.
 
  #4  
Old 01-14-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
just started recently. i had it installed over the summer.

Its not me holding the panic button down because my alarm has been going off while im in class and the truck is in the parking lot. I know cause my roommate has been walking by it and told me.

I dont have either of the door ajar or dome light issues. i cant say anything about the 45 minute intervals... sometimes it goes off sooner... sometimes longer.
 
  #5  
Old 01-14-2008
Rev's Avatar
Rev
Rev is offline
Member
Join Date: May 2005
Location: San Diego, CA
Posts: 1,179
Likes: 0
Received 7 Likes on 6 Posts
If they installed the isolation diodes on the door sensors one may have gone bad. The only other thing I can think of would be a problem with the door ajar switch, but you should see the dome or door ajar light flicker on at some point.

If the system was installed professionally I would stop back by their shop and let them take a look. If thats not an option then you'll need to start un-plugging trigger inputs at the alarm one at a time to narrow it down.

 

Last edited by Rev; 01-14-2008 at 01:41 PM.
  #6  
Old 01-14-2008
Jp7's Avatar
Jp7
Jp7 is offline
Member
iTrader: (9)
Join Date: Sep 2007
Location: N/A
Posts: 3,028
Likes: 0
Received 17 Likes on 14 Posts
I installed my "door is open" wiring to my dome light, If a thief were to open my door it would turn on my dome light and the alarm would go off.

When I had my Rotary Powered Focus it used to have the same alarm and I would go off in the winter while the car was losing the heat it had put in the cabin. It took almost 45 minutes, but I tracked this down and it was because of my shock sensor. Somehow it was temperature sensitive. I changed it to a new one and it went away. I still have the same alarm now that is in my truck. I probably have a few more sensors than you however.

I have:

2 Shock sensors
1 Proximity sensor
1 Glass break sensor
1 Battery low sensor
1 Hood tamper sensor
1 Door open sensor

If you removed your shock sensor and the only other one you have is the door sensor then it must be that. Either your switches are bad, or the alarm itself is bad.
 
  #7  
Old 01-14-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
new development here. I've begun to notice that my door ajar light will turn on when i go around a right-hand corner.
 
  #8  
Old 01-15-2008
nicholoff's Avatar
Member
Join Date: Sep 2007
Location: LANSING, MI
Posts: 339
Likes: 0
Received 0 Likes on 0 Posts
what brand and model would be a start to me helping you out.truck year also. it is probly a door pin issue
 
  #9  
Old 01-15-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
my bad. i thought i had that info in my sig.

01 edge supercab 4 door 4L sohc.

the alarm is aftermarket and i have actually not been curious enough yet to figure out what brand it is.
 
  #10  
Old 01-15-2008
WowMike2001's Avatar
Member
Join Date: Oct 2007
Location: Stevenson, WA
Posts: 2,583
Likes: 0
Received 3 Likes on 3 Posts
Originally Posted by Drayke
new development here. I've begun to notice that my door ajar light will turn on when i go around a right-hand corner.

my own truck does that.. take a right hand corner at a semi-decent speed to get a teeny bit of g's on the door.. and the door ajar will go off, soon as i straighten out and drive for a second, it shuts back off
 
  #11  
Old 01-15-2008
nicholoff's Avatar
Member
Join Date: Sep 2007
Location: LANSING, MI
Posts: 339
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Drayke
my bad. i thought i had that info in my sig.

01 edge supercab 4 door 4L sohc.

the alarm is aftermarket and i have actually not been curious enough yet to figure out what brand it is.
well figure out what brand it is so i can help you. and yeah mine door ajar beep comes on if my rear doors arent shut hard enough. i have to slam them shut.
 
  #12  
Old 01-15-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
aye, i figured that it was just a quirk and not related (door when turning thing)

As for the brand, ill take a look the next chance i get. probably be this weekend. keep this thread in mind. ill post it in here
 
  #13  
Old 01-16-2008
nicholoff's Avatar
Member
Join Date: Sep 2007
Location: LANSING, MI
Posts: 339
Likes: 0
Received 0 Likes on 0 Posts
what does your remote say?
 
  #14  
Old 01-16-2008
Drayke's Avatar
Member
Thread Starter
Join Date: Apr 2006
Location: LA / San Luis Obispo
Posts: 804
Likes: 0
Received 0 Likes on 0 Posts
lol. Brilliant!

the remote says: "CrimeStopper" and on the back:

"FCC ID: M65NVTX464"
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
mx98ranger
General Technical & Electrical
14
05-01-2017 07:54 AM
rideac1
OLD - Interior, Exterior, Electrical, & Misc.
3
04-17-2012 07:30 AM
04blackedge
OLD - Interior, Exterior, Electrical, & Misc.
0
07-22-2010 03:23 PM
mfp4073
General Technical & Electrical
7
09-08-2007 10:56 AM



Quick Reply: Alarm Issues - Possible Door Lock problems?



All times are GMT -6. The time now is 02:14 PM.