get out and push
#1
get out and push
Arrived home from home depot w/a load of lumber and attempted to back up the driveway and it just quit. This is a 2005 Ranger w/ 65000mi manual stans and has been running without a hitch since new. Checked all fuses, all good! looking for fuse links but don't know where to find them. The only thing that works is the "key in the ignition " alarm when you open the door. Ding ding ding! Are there any opinions as to what i'm looking at?
#3
#4
#5
#6
#7
#8
When you checked your Inertia switch, did you just push the button a few times?
If so, you did absolutely nothing. you have to trip the Inertia switch before you can reset it. Smack it with something hard. but not hard enough to break it, just hard enough to jolt the sensor in there. THEN hit the button.
It sounds like a PATS or Inertia thing. Do you have another key for the truck? Try that. I've heard stories of the system locking one key out.
do you have a steady Theft light on? if there is power when the key is in "on" you can have someone with a scanner to see if there is a code present.
If so, you did absolutely nothing. you have to trip the Inertia switch before you can reset it. Smack it with something hard. but not hard enough to break it, just hard enough to jolt the sensor in there. THEN hit the button.
It sounds like a PATS or Inertia thing. Do you have another key for the truck? Try that. I've heard stories of the system locking one key out.
do you have a steady Theft light on? if there is power when the key is in "on" you can have someone with a scanner to see if there is a code present.
#9
Thread
Thread Starter
Forum
Replies
Last Post
NewShockerGuy
General Ford Ranger Discussion
0
09-02-2014 09:13 AM
foxhallfred
General Ford Ranger Discussion
1
04-07-2012 06:16 PM
rangerrunner11
General Ford Ranger Discussion
6
11-17-2011 11:16 PM