1992 ford ranger "Internal Govenor"?
#1
1992 ford ranger "Internal Govenor"?
My wind shield wipers stopped working. the motor wouldn't run at all so i replaced the motor. the new motor still dose not run at all. originally I could hear a clicking sound coming from under the middle of the dash near the radio when I turned on the wipers. This noise would correspond to the speed I had the wiper switch set at. After I put the new motor in I could only hear the clicking sound when I first turn on the wipers. I checked the circuit breaker and that is good. I pulled the multi function switch off and all the wires are connected and the switch internals are all clean. I cant seem to find a relay on this vehicle for the wipers I was told It could be internal to the motor. I checked the wiring diagram and it shows a component called "internal Governor" that is part of the wiper circuit. dose anyone know what this component is, where it is located and if this could be the cause of my problem I am out of ideas. Thank you. you can see the wiring diagram at autozone.com
http://www.autozone.com/servlet/UiB...23d800ba9c7.jsp
click on 1992 ranger body wiring the component is in the bottom right corner of the diagram.
http://www.autozone.com/servlet/UiB...23d800ba9c7.jsp
click on 1992 ranger body wiring the component is in the bottom right corner of the diagram.
#2
Thread
Thread Starter
Forum
Replies
Last Post
B737
General Ford Ranger Discussion
53
01-07-2012 09:32 AM
straightedge
Audio & Video Tech
7
04-21-2006 01:45 PM