Using special fabrics on the headliner
#1
Using special fabrics on the headliner
Hey, I'm in the process of changing out my headliner, since the people who owned this truck before me were clearly using it for their own tobacco lab!
I go the headliner board out, now I want to put some cool, patterned fabric up there to personalize it. Anyone have any experience using stuff other than the stock interior foam-based fabric?
I know that it helps if it's stretchy, and I've read up a lot on how to get the old foam off the board, and such.
I want to put heat-blocker up there first, then some light foam-backed stuff, and ideally a nice cotton batik-patterned thing.
Originally I was going to just adhesive the batik to the board, but it's not stretchy, so now I"m leaning toward attaching it to the foam-backed stretchy fabric.
Any thoughts, folks?
Thanks, new Ranger owner and new member
I go the headliner board out, now I want to put some cool, patterned fabric up there to personalize it. Anyone have any experience using stuff other than the stock interior foam-based fabric?
I know that it helps if it's stretchy, and I've read up a lot on how to get the old foam off the board, and such.
I want to put heat-blocker up there first, then some light foam-backed stuff, and ideally a nice cotton batik-patterned thing.
Originally I was going to just adhesive the batik to the board, but it's not stretchy, so now I"m leaning toward attaching it to the foam-backed stretchy fabric.
Any thoughts, folks?
Thanks, new Ranger owner and new member
#2
I've not replaced a head liner in a ranger but I did in a Jeep Cherokee. I used a camo fleece fabric from the fabric store and stuck it with 3M spray adhesive. Spend the money and get the 3M, the cheaper stuff will let the fabric fall back down. It's stupid simple to do and gives the vehicle a very custom look. I even ended up doing the visors to match.
Headliner pulled out
Cleaned up the old foam. Be VERY careful to not mess up the form
Finished product. This is before I did the visors, and I ran my wiring hidden in the roof for my cb before reinstalling
Headliner pulled out
Cleaned up the old foam. Be VERY careful to not mess up the form
Finished product. This is before I did the visors, and I ran my wiring hidden in the roof for my cb before reinstalling
Thread
Thread Starter
Forum
Replies
Last Post
wydopnthrtl
General Technical & Electrical
50
10-01-2007 03:46 PM
bwester04
General Ford Ranger Discussion
24
06-09-2007 09:29 AM
2004FORDRANGER
Exterior Semi-Tech
22
04-04-2007 08:17 PM
VulcanMotor~PowerHouse
General Technical & Electrical
26
11-03-2005 05:59 PM