anybody install a fuel press gauge
 

just want to know where you installed the sending unit?

..what engine?

4.0l sorry

On the fuel rail. On the back left of the engine on the fuel rail there is a shrader test valve that the fuel pressure sender is attached to. Its a bit of a pain to get to on the 4.0. I've installed a couple different ones on my truck if you have any more questions.

theres another shrader valve on the rear? i see one on the front. i will take a look.

i dont think so. its a 4.0 sohc. 2008. the fitting with the gauge dosent work. so i ordered a ford fuel rail fitting from autometer hoping it would work but its the same size as the shrader valve. 1/16 nptf male ford fuel rail adaptor...3280 is the part #

here is the pic
http://photos-b.ak.fbcdn.net/photos-...15593_1643.jpg

nobody has done this?

Man I wish mine was on the front!

Mine is on the back passenger corner. I cant get to it with the blower on it, so I have yet to hook it up.

ya its nice that its on the front but i have nothing to adapt to it.

Summit Part

I'm 90% sure that's the fitting I used for mine. It screws on the shrader valve and adapts it to a 1/8th NPT which is the same as the fuel pressure sending unit that I have. Then I just got a double female connector from the hardware store.

thats what i am looking for a double female. i will take a look at the hardware store. i dont have anythig at work that size.

no fitting at home depot. where did tou find the fitting?

That fitting has a 1/16NPT. most hardware stores aren't going to have that small. Check an autoparts store, might get luck there.

Once I used the above listed fitting, I used a double female fitting of 1/8 NPT. My local hardward store had several different ones to choose from. 1/16 double female will be far more difficult to find.