sport trac OHC into an 07 ranger
#1
Join Date: Nov 2011
Location: Copper Cliff, Ontario
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
sport trac OHC into an 07 ranger
anyone on here ever swap in an OHC from a sport trac in a ranger. I have looked at all the how to's and they are all for pre-04 rangers and with explorer ohc. mine is from an 04 sport trac, there was no mounting bracket, it's only held in place by 2 spring clips, no screws at all.....
any advice?
any advice?
#3
Join Date: Nov 2011
Location: Copper Cliff, Ontario
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
nope, no screws, when i was getting the leather seats and rims from the guy, i asked him how much for the ohc and he said if you can get it out, it's yours. I reached up near the windshield, pressed up on the headliner enough to get my fingers under the lip of the ohc, and pulled down, wasn't expecting it to pop off completely, i was sure there would be 2 screws, but no, just 2 clips, and no bracket, the clips go directly into the crossmember supporting the roof near the windshield. now this did have a sunroof, and there is a very small lip that was under the sinroof trim, like a 1/16" (1-2 mm) lip at best, and the sunroof trim was like a softer rubber like trim, no real holding power.
#5
Join Date: Nov 2011
Location: Copper Cliff, Ontario
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
99offroadrngr
OLD - Interior, Exterior, Electrical, & Misc.
9
05-07-2010 11:50 AM
zabeard
General Ford Ranger Discussion
35
08-07-2007 06:43 AM
moacsupreme
Exterior Semi-Tech
4
01-14-2007 06:54 PM