Removing Interior Door Panel 2008
#1
#2
#3
#4
Your profile says "2008 Ranger XLT" so that is why I am assuming you have the XLT door panels (the ones with a map pocket at the bottom). Also, you have power accessories, so you should have the better door panels.
this door handle bezel is from a non-powered XLT door panel, virtually the same as a power optioned door panel, Note the screw locations behind the grab handle:
this door handle bezel is from a non-powered XLT door panel, virtually the same as a power optioned door panel, Note the screw locations behind the grab handle:
Last edited by bwester04; 05-10-2008 at 06:30 PM.
#6
#7
Not sure on an '08.. but on an '02-05, there are areas where you would stick a flathead screwdriver and gently pry up/twist motion and the glass 'pops' off. You could check and see if there is something similar on your '08, just play around with the position of the mirror and look around the base where the glass mounts.
#8
Member
iTrader: (1)
Join Date: Dec 2007
Location: Ocala, Fl & Woodland, WA
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
If you haven't figured out how to get the mirror off yet, click below.
http://www.pdfdownload.org/pdf2html/...pdf&images=yes
http://www.pdfdownload.org/pdf2html/...pdf&images=yes
#9
If you haven't figured out how to get the mirror off yet, click below.
http://www.pdfdownload.org/pdf2html/...pdf&images=yes
http://www.pdfdownload.org/pdf2html/...pdf&images=yes
Thread
Thread Starter
Forum
Replies
Last Post
NinjaGinga1101
OLD - Interior, Exterior, Electrical, & Misc.
8
01-23-2015 07:59 PM
Shuck
OLD - Interior, Exterior, Electrical, & Misc.
1
01-22-2011 01:29 AM
lm700
General Ford Ranger Discussion
10
09-26-2010 12:13 PM
pacodiablo
OLD - Interior, Exterior, Electrical, & Misc.
0
03-05-2010 02:27 PM