Dumping my duals????
#1
Dumping my duals????
Ok I have a set of flowmaster duals on my truck. Got it done about 2 years ago. I was wondering if i just cut em shorter underneathe and just heat the pipe up and 90 it down or buy a set of 90 tips and weld em on? Would that work? Make it sound better? Any of you done this? Just looking for ideas?
#4
#6
#13
I did the same to my 2.5, only without the turn-downs. It made it much, much deeper (inside and out), and it really resonates a nice tone in the cab and within 20 feet of the truck now. My wife hears me when I pull into the neighborhood, and we live 100 yards or so from the entrance. I pull in at idle or just bare above it.
I'd recommend it, but be prepared to turn up the radio a few more notches!
I'd recommend it, but be prepared to turn up the radio a few more notches!
#18
#21
#23
now you are planning on keepin ghte flow master mufflers right? and just dumping the piping right before the rear axle?, well it will be a little bit louder but it shouldnt make that much of a differenace, i wnet from dual out the back to basically the same thing with Two Dynomax mufflers and it really didnt chance the sound of the vehicale much at all... its basically piping you are taking away just try not to dump it under the cab or else you will get that droning effect and it just gets anoying after a min or two....