3in exhaust?
#1
3in exhaust?
well i'm tired of my stock exhaust and got a flowmaster given to me and have a bunch of 3in stainless that id like to use with the flowmaster, so what i was thinkin was to unbolt the exhaust from the cat back (already have the muffler and tubing that goes over the axel out) and cut the stock pipe just a little bit back from the stock flange so i can weld the 3in to that to bolt it back up and then put my flowmaster in the place that the stock one was and then go 3in all the way out, will it hit anything goin over the axel or should i clear it? has anyone done this before? if so could i see some pics please and possibly a clip of how it sounds
#2
#6
#9
#12
Found the clip, can't figure out how to post it here, so heres the link to the site. http://www.therangerstation.com/foru...t=80790&page=3 . ** this is not my truck, but a member of that forums.
Thread
Thread Starter
Forum
Replies
Last Post
CjRanger99
General Ford Ranger Discussion
19
05-26-2005 12:36 AM