Ranger-Forums - The Ultimate Ford Ranger Resource - Search Results

 
Search: Posts Made By: sheltonfilms
Showing results 1 to 25 of 500
Search took 0.08 seconds.
05-11-2017
Replies: 4
Views: 7,312
Posted By sheltonfilms

Never had a problem with that clip/bushing, but I...

Never had a problem with that clip/bushing, but I did have to replace the column shifter tube bushings. Looks like yours are about gone as well.

Dorman part# 905-107
04-22-2017
Replies: 5
Views: 2,642
Posted By sheltonfilms

I replaced mine at 180k miles. Original Belt....

I replaced mine at 180k miles. Original Belt. 100k miles to me is still to early.

Still have factory serpentine belt on my truck at 235k miles.
04-22-2017
Replies: 5
Views: 504
Posted By sheltonfilms

Remove the balancer/pulley and put a dial...

Remove the balancer/pulley and put a dial indicator on the shaft and rotate the crankshaft using the bolt. May want to start on one side of the key slot and rotate it until you get to the other side....
04-06-2017
Replies: 5
Views: 1,595
Posted By sheltonfilms

Audio control wire is Light Blue/ Red. Check last...

Audio control wire is Light Blue/ Red. Check last page of this:

http://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=14072
04-05-2017
Replies: 9
Views: 3,926
Posted By sheltonfilms

Pin 1 (either Blue/Orange or Pink/Orange needs to...

Pin 1 (either Blue/Orange or Pink/Orange needs to be jumped to ground (or pin 7) which should be Black/White in color.
04-05-2017
Replies: 9
Views: 3,926
Posted By sheltonfilms

The PATS module grounds out the starter relay...

The PATS module grounds out the starter relay when everything is good for starting.

On a non-pats car this wire is already grounded.

Simple put: Put new non-Pats PCM into truck. Remove PATS...
04-05-2017
Replies: 4
Views: 376
Posted By sheltonfilms

Do you have power windows and mirrors? If you do...

Do you have power windows and mirrors? If you do then you have power locks. (*****EDIT**** just saw where you have hand crank windows, so you shouldn't have power locks but you may still be wired for...
04-05-2017
Replies: 2
Views: 352
Posted By sheltonfilms

Follow the small 1/4-3/8 pipe seen between runner...

Follow the small 1/4-3/8 pipe seen between runner 1 and 2 upto the throttle body:

http://www.explorerforum.com/photopost/data/3943/0601121251a.jpg
04-05-2017
Replies: 2
Views: 352
Posted By sheltonfilms

Sound like a bad vacuum leak. Check to make sure...

Sound like a bad vacuum leak. Check to make sure the large vacuum hose is connected that goes from the metal pipe between intake runners 1 and 2 up to the bottom of the throttle body is connected....
08-18-2016
Replies: 3
Views: 671
Posted By sheltonfilms

As stated above a pressure test is needed. ...

As stated above a pressure test is needed.

Bicycle pump will be good to use.

BTW you can make your readings more sensitive by adding water to the heater core.

The smaller the air chamber...
06-06-2016
Replies: 4
Views: 548
Posted By sheltonfilms

Maybe but it's cheaper to go a 3rd party route....

Maybe but it's cheaper to go a 3rd party route. I've seen them as low as $50 bucks.
06-06-2016
Replies: 8
Views: 1,707
Posted By sheltonfilms

You need 4 harnesses: Driver door w/ power...

You need 4 harnesses:

Driver door w/ power options. (2000 or 2001)
Pass door w/ options. (99 works and so does 00)
Dash harness (must get a 2000) and must have 2wd. 4wd or 4wabs has a different...
06-06-2016
Replies: 4
Views: 548
Posted By sheltonfilms

The restraints control module (air bag module) is...

The restraints control module (air bag module) is the sensor itself. It is located behind your cupholders/gear shifter.

This module sets a HARD error when a crash is detected and stores the crash...
03-21-2016
Replies: 5
Views: 511
Posted By sheltonfilms

Try swapping the two relays and see if it changes...

Try swapping the two relays and see if it changes anything.

Diagram:
http://www.revbase.com/BBBMotor/Wd/DownloadPdf?id=46791
03-09-2016
Replies: 6
Views: 3,740
Posted By sheltonfilms

Eddie Bauer or Limtied Explorer. You have to use...

Eddie Bauer or Limtied Explorer. You have to use the clockspring from the vehicle you pull the wheel from. That 6 way brown connector gets a little bigger. More wires for the radio and more wires for...
Replies: 5
Views: 1,509
Posted By sheltonfilms

Word of advice. If I remember correctly the 2000...

Word of advice. If I remember correctly the 2000 had m10 bolts that threaded into the exhaust flange. The 97 has m12. I used m10 when I put the new header on and put nuts on the flange side.

That...
02-16-2016
Replies: 0
Views: 1,483
Posted By sheltonfilms

1998-2000 Bit the Projector Bullet / Still Chewing

Been wanting to do this forever but it can be expensive. I had to work overtime over the Thanksgiving holiday and that gave me an awesome paycheck. Combine that with 25% from theretrofitsource.com on...
02-06-2016
Replies: 3
Views: 602
Posted By sheltonfilms

It shows it under diagram 59-2 in the...

It shows it under diagram 59-2 in the electrical/vacuum service manual.
Replies: 5
Views: 1,509
Posted By sheltonfilms

I put a 97 header on and had to weld the bung on...

I put a 97 header on and had to weld the bung on the down pipe. Need longer bolts. See thread for all details:

Exhaust manifold difference - Ford Ranger Forum...
02-01-2016
Replies: 7
Views: 623
Posted By sheltonfilms

Don't be THAT GUY and buy a plug and play kit....

Don't be THAT GUY and buy a plug and play kit. Save your money and do a true HID retrofit.

HIDs need to be in a projector and one made for them. Definitely not in a reflector housing that blinds...
01-25-2016
Replies: 12
Views: 4,326
Posted By sheltonfilms

Well dang that sucks. Well I guess I got a...

Well dang that sucks.

Well I guess I got a few options.

1. Do like yours and bend the wire so the grommet is in the center (makes a really long extension).

2. Cut a slot in the bottom for...
01-25-2016
Replies: 12
Views: 4,326
Posted By sheltonfilms

You have a AMP to D2S adapter? ...

You have a AMP to D2S adapter?

https://www.theretrofitsource.com/media/catalog/product/cache/1/image/1a8932787757a8ae4cbc8144a20b336f/t/r/trs_straight_amp_d2s_adapters_1.jpg
01-24-2016
Replies: 12
Views: 4,326
Posted By sheltonfilms

So I'm retrofitting a 1998-2000 style headlight...

So I'm retrofitting a 1998-2000 style headlight which is very similar to the Mazda B-Series bucket. I got the mini D2S projector in it now.

I went out and got some 3 inch pipe and the fernco pvc...
Replies: 12
Views: 8,952
Posted By sheltonfilms

You will only get vacuum at MAX A/C and OFF. When...

You will only get vacuum at MAX A/C and OFF. When vacuum is applied the valve shuts the heater core off. So when you have it on heat and you don't feel vacuum this is normal.

Just draining from...
01-11-2016
Replies: 6
Views: 839
Posted By sheltonfilms

As I don't have 4WABS, I can say if you can do...

As I don't have 4WABS, I can say if you can do this or not.

Sends its speed dependent, see if you see individual wheel speeds: front left, front right, rear. Should be in the 4wabs module.

If...
Showing results 1 to 25 of 500
 


 

Contact Us - Sitemap - Advertising - Cookie Policy - Privacy Statement - Terms of Service

© 2019 MH Sub I, LLC dba Internet Brands

We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.