Ranger-Forums - The Ultimate Ford Ranger Resource - Search Results


Showing results 1 to 25 of 26
Search took 0.01 seconds.
Search: Posts Made By: Shadowmeph
Forum: 4.0L OHV & SOHC V6 Tech 4 Days Ago
Replies: 11
Views: 344
Posted By Shadowmeph
Dam I should have mention this before hat I do...

Dam I should have mention this before hat I do have a code but it is p0457 evap code usually I get the gas cap lose but I have replaced it a little later I get the check engine with that code. now I...
Forum: 4.0L OHV & SOHC V6 Tech 4 Days Ago
Replies: 11
Views: 344
Posted By Shadowmeph
thanks . the leak does appear to be just below...

thanks . the leak does appear to be just below the over flow hose didn't think about that .
Forum: 4.0L OHV & SOHC V6 Tech 5 Days Ago
Replies: 11
Views: 344
Posted By Shadowmeph
finally got my truck back runs good they replaced...

finally got my truck back runs good they replaced the rear main seal with an OEM one because apparently the other one didn't seal properly .
when I got my truck back I drove into work and noticed...
Forum: General Ford Ranger Discussion 5 Days Ago
Replies: 1
Views: 70
Posted By Shadowmeph
small rad leak

finally got my truck back runs good they replaced the rear main seal with an OEM one becasue apparently the other one didn't seal properly .
when I got my truck back I drove into work and noticed...
Forum: General Technical & Electrical 1 Week Ago
Replies: 11
Views: 280
Posted By Shadowmeph
water pump ? on my older vehicals it was usually...

water pump ? on my older vehicals it was usually Fan belt or water pump sometimes on rare occasions Power steering pump
Forum: 4.0L OHV & SOHC V6 Tech 2 Weeks Ago
Replies: 11
Views: 344
Posted By Shadowmeph
when I first got this truck the pedal was close...

when I first got this truck the pedal was close to the top now it is around 1-2 inches from the floor being old school at first I thougght the system would be the same but now finding out that it is...
Forum: 4.0L OHV & SOHC V6 Tech 2 Weeks Ago
Replies: 11
Views: 344
Posted By Shadowmeph
Ok so .. I am not sure if I mentioned his already...

Ok so .. I am not sure if I mentioned his already but I didn't realize that when I bought this truck it was a rebuild I thought rebuilt engine but on my reg it says rebuilt which is entirly...
Forum: 4.0L OHV & SOHC V6 Tech 05-09-2018
Replies: 11
Views: 344
Posted By Shadowmeph
the big thing is I am not sure what my truck is...

the big thing is I am not sure what my truck is worth
Forum: 4.0L OHV & SOHC V6 Tech 05-09-2018
Replies: 11
Views: 344
Posted By Shadowmeph
time to sell

well thinking of selling this 04 4.0 5speed manaul ranger ,
after what I went through which I posted here...
Forum: 4.0L OHV & SOHC V6 Tech 05-04-2018
Replies: 13
Views: 254
Posted By Shadowmeph
I am tending to agree with you on this ,...

I am tending to agree with you on this , Sometimes crap happens most shops have 1 maybe to Licensed Mechs all the others are either trainees or like myself way back when I worked I wasn't licensed...
Forum: 4.0L OHV & SOHC V6 Tech 05-04-2018
Replies: 13
Views: 254
Posted By Shadowmeph
I am not sure what sending them an email with a...

I am not sure what sending them an email with a link to this forum will do .

Anyway if something like this happens again I am not going back top them. the next thing I have to do if this problem...
Forum: 4.0L OHV & SOHC V6 Tech 05-03-2018
Replies: 13
Views: 254
Posted By Shadowmeph
That is them

That is them
Forum: 4.0L OHV & SOHC V6 Tech 05-03-2018
Replies: 13
Views: 254
Posted By Shadowmeph
So I picked up my truck the switch was replaced...

So I picked up my truck the switch was replaced with used the wires to the switch were burn't a bit the plastic connected was melted . if i would have known i would have just put a toggle switch on...
Forum: 4.0L OHV & SOHC V6 Tech 05-03-2018
Replies: 13
Views: 254
Posted By Shadowmeph
am I being burned for Fuel pump cost?

last week while driving to work my 04 4.0 4x4 edge ranger stalled out while driving down a steep hill. fortunately being a 5 speed manual I was able to ease into the slow lane press the clutch and...
Forum: Drivetrain Tech 06-08-2017
Replies: 4
Views: 361
Posted By Shadowmeph
Great thank you ,

Great thank you ,
Forum: Drivetrain Tech 06-07-2017
Replies: 4
Views: 361
Posted By Shadowmeph
no leak that I can see I seen a you tube video...

no leak that I can see I seen a you tube video person has the same drive shaft with same play and knocking noise https://www.youtube.com/watch?v=xSGPpqjKer0 the exact same on mine but I have no oil...
Forum: Drivetrain Tech 06-07-2017
Replies: 4
Views: 361
Posted By Shadowmeph
clunk when shifting plus vibration

ford ranger 2004 5 speed standard 4x4 . I have been putting off the mild clunking noise and I don't do allot of highway driving but Idid notice the other day when I was on the Hwy at around 110Km\h...
Forum: 4.0L OHV & SOHC V6 Tech 05-26-2017
Replies: 15
Views: 550
Posted By Shadowmeph
when I bought the truck 2 years ago I noticed...

when I bought the truck 2 years ago I noticed that one of the bolts were missing on the truck bed and I can actually slightly lift the upper corner of the bed where the gas filler is. SO if anywhere...
Forum: 4.0L OHV & SOHC V6 Tech 05-24-2017
Replies: 15
Views: 550
Posted By Shadowmeph
SO did the wires and plugs Number 3 cylinder took...

SO did the wires and plugs Number 3 cylinder took a while to replace plug but I got it. the funny thing is the 1-3 plugs were loose, no more miss fires when engine is wet.
one thing that I noticed...
Forum: 4.0L OHV & SOHC V6 Tech 05-21-2017
Replies: 15
Views: 550
Posted By Shadowmeph
hmm so I checked all the fires appear to be ok. I...

hmm so I checked all the fires appear to be ok. I am now debating on buy all new plugs wires and coil pack , and I am not really looking forward to doing the plugs closest to the firewall.
any...
Forum: 4.0L OHV & SOHC V6 Tech 05-20-2017
Replies: 7
Views: 965
Posted By Shadowmeph
I didn't know this, is this the same for a 2004...

I didn't know this, is this the same for a 2004 ranger 4x4 4.0 ? so off question here but I take it if the COmputer gets swapped out that the truck won't start?
Forum: 4.0L OHV & SOHC V6 Tech 05-20-2017
Replies: 15
Views: 550
Posted By Shadowmeph
thanks people. I am going to check the fuel...

thanks people. I am going to check the fuel injector wire ,
I did forget to mention on my scan reader it came up with A couple of codes the first is P0457 hoping it is a gas cap problem the other...
Forum: 4.0L OHV & SOHC V6 Tech 05-19-2017
Replies: 15
Views: 550
Posted By Shadowmeph
that makes total sense, I was just outside and...

that makes total sense, I was just outside and the connector is at the center of firewall.
I need to pull the connector off and check for corrosion, if I find a little corrosion and am able to clean...
Forum: 4.0L OHV & SOHC V6 Tech 05-19-2017
Replies: 15
Views: 550
Posted By Shadowmeph
"2004 should have 104 wire computer connector in...

"2004 should have 104 wire computer connector in engine bay upper center of firewall."
I am not sure what your talking about here are you talking about the wiring harness connecting to the...
Forum: 4.0L OHV & SOHC V6 Tech 05-19-2017
Replies: 15
Views: 550
Posted By Shadowmeph
after a few say I drive for a little bit then...

after a few say I drive for a little bit then stop restart engine seems to go away. also occasionally happens on rainy wet days it will start up running rough but same thing I drive it shut truck...
Showing results 1 to 25 of 26

 

All times are GMT -6. The time now is 11:34 PM.


We are a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for us to earn fees by linking to Amazon.com and affiliated sites.