Son of a ....!!!!!!!!!!!
your kidding?! We loaded up a 800lb dixie narco pop machine leaned it against the tailgate and had a bunch of people lift and slide er in. Unless the thing is rotted or work hardened from open close open close, or someone kinked it thus weakening the structure..... i don't get it.
your kidding?! We loaded up a 800lb dixie narco pop machine leaned it against the tailgate and had a bunch of people lift and slide er in. Unless the thing is rotted or work hardened from open close open close, or someone kinked it thus weakening the structure..... i don't get it.
your kidding?! We loaded up a 800lb dixie narco pop machine leaned it against the tailgate and had a bunch of people lift and slide er in. Unless the thing is rotted or work hardened from open close open close, or someone kinked it thus weakening the structure..... i don't get it.
Yah that might be it, they might've been rotted, doesn't really matter..
All that matters is pic
funny.....had one (the only one left) on my 1st gen project snap on me this morning as i jumped in the bed
made me fall flat on my a$$ and knocked the wind outta me
they were both rotted and rusty...it was gonna happen sooner or later
made me fall flat on my a$$ and knocked the wind outta me
they were both rotted and rusty...it was gonna happen sooner or later
yeah but it was once in the salt belt, cables dont last long up here.
Joined: Jun 2008
Posts: 5,584
Likes: 0
From: Mooresville, NC
It's not that bad but it's still a dent where there wasn't one before. Just pisses me off the first time I get in the bed after the swap and snap!!
I'm about 200 lbs and jumped to sit up on the tailgate so I can get in this tall *** thing like I've done a 1000 times.
Funny thing is I was talking with Mike about swapping the cables but didn't bring a torx bit. I had fairly new autozone cables on mine because I had one break in the past.
I'll get a pic after work.
I'm about 200 lbs and jumped to sit up on the tailgate so I can get in this tall *** thing like I've done a 1000 times.
Funny thing is I was talking with Mike about swapping the cables but didn't bring a torx bit. I had fairly new autozone cables on mine because I had one break in the past.
I'll get a pic after work.









