Done Some Thinking!!
Done Some Thinking!!
I have noticed some trucks on here that have the camo border running along the bottoms of the truck!! How can i do that?
Also. Josh u and mike said i need shackles and something else? Where can i buy those and how much? Thankes guys.
Also. Josh u and mike said i need shackles and something else? Where can i buy those and how much? Thankes guys.
Why would he do spindles? Thats for the front, obviously he wants to lift the rear. 2wd or 4wd has nothing to do with it.
Shackles you can get from Summit racing for around 40-50 if I remember correctly.
Shackles you can get from Summit racing for around 40-50 if I remember correctly.
Well if he was going to lift his truck I would do spindles which is 2wd as you know. I was not for sure if he wanted To lift the front and back. So I said a possibly for the front.
Stuff Like This.
http://www.camomyride.com/i/3009chase-truck.jpg
http://www.camomyride.com/i/3009chase-truck.jpg
And yes it is a 2wd...
http://www.camomyride.com/i/3009chase-truck.jpg
http://www.camomyride.com/i/3009chase-truck.jpg
And yes it is a 2wd...
Oh Yea. I should have worded Different.
Here is a link for shackles.
http://store.summitracing.com/partde...0&autoview=sku
Here is a link for shackles.
http://store.summitracing.com/partde...0&autoview=sku
To the OP: You should have said that! You have a couple different choices. Theres a 5.5" fabtech kit you can get that has spindles, coils and arms or the 3" kit that is just spindles I think.
Im 2wd and im working on getting my truck spindles for the front and AAL in the back. Im also going with the 3" body lift and will be on 33's when im all done. You can check out my project log in the project log forum.
If you do go with 33's you would want to re gear to a 8.8 with 4.10's
If you do go with 33's you would want to re gear to a 8.8 with 4.10's
He can do shackles and coil spacer to gain 2" or so all the way around and not spend to much.
Thread
Thread Starter
Forum
Replies
Last Post
Kosmo04
General Technical & Electrical
3
Feb 7, 2007 05:01 PM







