Explorer seats are in...
#1
#2
#6
The seats were almost a direct bolt. The passenger seat had 2 holes and the drivers 1 that were too small for the ranger seat bolts to fit through. I drilled them out with a 1/2" bit and worked great. I had to run a new wire for the power in the driver seat but that was easy also. I used the ranger seatbelts and secured them to the explorer seats with a nut and bolt. The spot I choose was on the explorer tracks, I drilled those out with the same 1/2" bit (also very easy) and then bolted them on with grade 8 bolts. Swap was very easy and straight foward. I used my new snap-on impact so the swap was painless and done quickly. Took me longer to clean than anything else. I also found like $12 in change between the two trucks. Only issue is I worked so long on a nice a$$ groove in the old seats and now I got to start over :(
#7
Thread
Thread Starter
Forum
Replies
Last Post
For Sale: Seats, seats, SEATS! NC
drppdyllwrngr
OLD - Interior, Exterior, Electrical, & Misc.
30
03-16-2010 07:38 PM
Njc0013
Interior Semi-Tech
0
02-03-2010 11:29 AM