Nice day= New clean pics!
Dude I have answered that question every time you have asked and that has been a lot of times. If you still don't know then PM me.
What he NEEDS to do is the following:
'99-00 non ugly bumper strip bumper + painted black valence.
OR...
01-05 chrome upper + 01-03 EDGE valence painted F4 red.
Same question here... Also, wouldn't it make sense to put the raised cross member on a 4x4 for more ground clearance? I'd have to look at my truck... The torsion bar cross member is probably lower anyhow lol
Have you guys even looked at your torsion bar brackets??? the crossmember bolts to the inside of the torsion bar brackets.
coil spring trucks tranny crossmembers bolt to the outside of the frame and hang way down. billy's stocker was beat up pretty good from scrapping my driveway! lol.
Damn, nice and clean truck and pics!!!
Wish I had nice weather like that here. It was not as cold today so I ran mine through the automated pressure wash. Does a great job of getting it clean and salt free, but it's just not the same as hand washing.
Ah well, spring is just around the corner...................................a very long corner.
Wish I had nice weather like that here. It was not as cold today so I ran mine through the automated pressure wash. Does a great job of getting it clean and salt free, but it's just not the same as hand washing.
Ah well, spring is just around the corner...................................a very long corner.
what the heck are you guys talking about bad weather? It's been nice and toasty here...
Truck looks good.. but is it just me or does your driver front fender have alignment challenges? maybe its just a shadow that's throwing me...
Truck looks good.. but is it just me or does your driver front fender have alignment challenges? maybe its just a shadow that's throwing me...
i also have a 2wd coil sprung front end and i was wondering for it. Cause since i have owned it i have been kinda lifting it and it just kinda also looks like it would give the truck a more cleaner look to it
not on your edge...you got torsion bars....
Thread
Thread Starter
Forum
Replies
Last Post





