02 Ranger Edge
#1
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
#4
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
i like it horizontal since when ever i get my pipes out the back it will be easier to run them, sorry cant send you the bumber and valance i need it
im gona get it painted soon right now $$ is tight but i think i just saved some money just by replacing a little fuse
but soon a body lift im just too busy looking for a job to do anything
im gona get it painted soon right now $$ is tight but i think i just saved some money just by replacing a little fuse
but soon a body lift im just too busy looking for a job to do anything
#7
You're going to get the grille painted soon? You dont have to hardly have any money to paint a grille. Just pull off the grille surround with the grille intact and tape off the surround and take off the emblem then get to spraying. Takes about a day to do it. You drive around without a grille for a day. I did. LOL
#8
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
plans
my plans are a PA 3inch body lift, bigger tires after these are worn, K&N air intake, and pipes and get the pipe between the cat and muffler changed to 2.5 for better air flow after the K&N intake
i barely have any money, all in college and since i dont have a job but am looking its hard to do stuff
but i think i just saved some money cause my airbag light was on and i was looking in the book and saw that my 4x4 system was fuse #5 so i pulled it out and it looked messed up so i replaced it, well i was looking at a post on here about body lifts and it said that the airbags were #5&6, but when i went for a ride today to dry the truck off, the light didnt come on so i think i fixed it. time will tell
i barely have any money, all in college and since i dont have a job but am looking its hard to do stuff
but i think i just saved some money cause my airbag light was on and i was looking in the book and saw that my 4x4 system was fuse #5 so i pulled it out and it looked messed up so i replaced it, well i was looking at a post on here about body lifts and it said that the airbags were #5&6, but when i went for a ride today to dry the truck off, the light didnt come on so i think i fixed it. time will tell
#10
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
#13
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
#16
#17
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
#18
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
#21
Join Date: Sep 2009
Location: NC
Posts: 242
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Strider0O0
General Ford Ranger Discussion
25
03-08-2017 02:08 PM
SpykeYs
General Technical & Electrical
11
04-16-2007 07:52 PM