removed step bars
#3
real rusty inside, the plastic step plates had rust under them and a big hole on the drivers side. going to fill the area where the step plates were with fiberglass cloth/resin, sand and paint the outside with bedliner spray, for the inside of the tubes im thinking of either using expanding construction foam or using a pull wire to drag strips of fiberglass cloth through, then fill them with fiberglass resin. if i had access to a air-powerd grease gun with a big grease supply, i could just put a grease fitting on both and fill them with grease, but imagine the mess once you did get a pinhole and it gets hot out. ive just been laid off, so ive got some time to work on them. but thats another story, working for a company that supplies parts to a japanese automaker, cutbacks due to obvious japan disaster. dont know if unemployment will be worse than reduced hours at regular pay, but i didnt get the choice. thats life i guess.
Thread
Thread Starter
Forum
Replies
Last Post
Jay524
OLD - Interior, Exterior, Electrical, & Misc.
15
06-09-2014 08:17 PM
zane_pauls
Exterior Semi-Tech
11
05-14-2012 05:45 PM
BILTRITE BULLIES
OLD - Suspension, Tires, & Wheels
31
07-03-2010 08:50 PM