1999 2.5 Tach hook up
#1
#2
Got it done!
Found this on the ranger station.
A - Its not hard at all. The powertrain plug is located under your hood on the passenger side of the engine compartment in the rear. It is a pretty big plug - about four inches long or so. In that cluster of wires is a yellow wire with a brown stripe. that is the one I hooked my tachometer up to in my 1999 Ranger with the 2.5
that took care of it!
A - Its not hard at all. The powertrain plug is located under your hood on the passenger side of the engine compartment in the rear. It is a pretty big plug - about four inches long or so. In that cluster of wires is a yellow wire with a brown stripe. that is the one I hooked my tachometer up to in my 1999 Ranger with the 2.5
that took care of it!
#3
RF Veteran
iTrader: (1)
Pin 48 on PCM(the big connector on firewall) has the tach signal, it should already be wire to the instrument cluster, and yes a tan/yellow stripe wire at that end
You won't find it just look at wires under the dash, you have to pull out the cluster
You can swap clusters to get stock tach
You won't find it just look at wires under the dash, you have to pull out the cluster
You can swap clusters to get stock tach
Thread
Thread Starter
Forum
Replies
Last Post
ranger64
General Technical & Electrical
1
07-03-2014 12:28 AM
01xltranger4x4
General Technical & Electrical
16
02-03-2006 11:53 PM