Truck Wont Start Please Help
#1
Truck Wont Start Please Help
I have a 1991 ford ranger with a 2.3l 5 speed. recently ive been starting the truck with a switch attached directly to the stater cylinoud but today when i went to start it the switch didnt so i tryed useing a screw driver to jump across the cylinoud but that didnt work ether so im lost. does anyone have any ideas on what the problem might be? Please help...
#2
#5
i have a question about 2 weeks ago my clutch pedal senser went out and thats why i put the switch in. also i replace that and still no luck and then now this happened could it be something to do with the ignition???
#6
if the ignition switch where bad you could still crank the eng. over by jumping across the solenoid. it would crank but not start. so i don't think it is the ignition. check for a bad ground / loose connection / or dead battery. if all checks out good then check the wires going to the starter and the starter itself.
#7
Thread
Thread Starter
Forum
Replies
Last Post
glockboy40cal
4.0L OHV & SOHC V6 Tech
0
11-29-2012 02:47 PM