2.5 timing belt vs 2.3
#1
#3
125000, now I'm sitting here ready to pull old belt off and I'm screwed with a damper that won't slide off, obviously I need a puller but what size bolts are in th damper for puller to grab??? Gotta be metric because 1/4" bolt is too small. Help
#4
well found that problem, they were m8x1.25's or so, whatever course is. anyhow got the new belt on and damper installed, and the marks dont line up 100% but their not off enough to call it a tooth, just a hair off. is it normal for these marks not to be lined up 100%? i set crank dead even on timing marks, but oil pump and cam are just a hair off. engine spins over when turning by hand on the crank, and clearly has compression(i.e. it gets to that point and spins itself a bit)
Thread
Thread Starter
Forum
Replies
Last Post
dixie_boysles
4.0L OHV & SOHC V6 Tech
1
01-09-2017 07:31 AM