Engine swap blues
#1
Engine swap blues
I bough a 99 Ranger xlt with a bad 2.5 and i have a 2.5 engine, that having been said I started the truck before the tear down so I know it ran it ran very bad but it ran but after the engine swap the I can't seam to get the 2.5 engine to run.
I checked for fuel witch I have and for spark it had no spark so I checked all the fuses I found the (PCM Diode fuse) was blown I replaced it and the engine would start but it ran very rough and died out, after checking vacuum lines and grounds I tried starting it again to find I was back to square one no start and all the fuses look good so now I'm out of ideas and any suggestions would be helpful.
I checked for fuel witch I have and for spark it had no spark so I checked all the fuses I found the (PCM Diode fuse) was blown I replaced it and the engine would start but it ran very rough and died out, after checking vacuum lines and grounds I tried starting it again to find I was back to square one no start and all the fuses look good so now I'm out of ideas and any suggestions would be helpful.
Thread
Thread Starter
Forum
Replies
Last Post