Steering on sas
#28
Sas on ranger
I didnt like the look of the other setup on the axle spacers so I did this. It's not finished but wedges fit this better. The radius arms dont look like much but I'll clean em up and fresh paint. They came used from Tom's bronco part in Oregon. I'm planning on getting 5.5 in lift coils from rock crawler. Still have to finish axle. New hubs, brackets for calipers. Not sure what goes on end of hub that you see when tires are on. It didnt have manual locking hubs. Just a cover of some sort. I've only seen them as part of a kit? More to come as I get more done. I'm an older fat, I go slow...lol
#30
Sas on ranger
Ok, a question for anyone that feels they know enough to answer, which most of u probable can. I called Tom's bronco parts and talked to a tech guy about the angle for wedges for radius arms. He told me they should go on with front being 23 degrees down from 90, horizontal. Rear should be about 35 degrees up from 90. This does seem like it would help put upper and lower ball joints right for castor. I was planning on tacking wedges and test fitting axle then if all looks ok I'll take it apart, finish welding wedges, put it together hopefully for good. Anyone got any input on this?
Thread
Thread Starter
Forum
Replies
Last Post
zabeard
Fabrication & Tool Tech
54
08-14-2017 12:40 PM