8.8 exploder swap / flip kit
#1
8.8 exploder swap / flip kit
I am planning on swapping out my puny 7.5 for an 8.8 Exploder rear-end with discs.
Also dropping the truck this summer. Since the Explorer axles are already mounted on top of the spring can I get away with bolting it in using the existing spring perches? I know shock mounts will still need to be modified.
Anyone done this before?
Also dropping the truck this summer. Since the Explorer axles are already mounted on top of the spring can I get away with bolting it in using the existing spring perches? I know shock mounts will still need to be modified.
Anyone done this before?
#2
#3
#4
i'm not sure why that is, but i have ran into an issue that may be part of the reason. i'm planning to put a bronco II tank behind my axle. but to do that, i will have to relocate the shock back in front of the axle.
if you plan to relocated the passenger shock to behind, you don't need to get two of one side, but a driver and passenger side plate.
if you plan to relocated the passenger shock to behind, you don't need to get two of one side, but a driver and passenger side plate.
Thread
Thread Starter
Forum
Replies
Last Post