Adding rear sway bar after axle flip??
Ok, so I am going to install a rear sway bar kit...Addco #480 since I found it for $160ish. My question is this...I have done an axle flip (4" on my 7.5" axle) and then installed 1" Belltech F-150 drop shackles to equate to a 3" drop in the rear. Will the Addco kit fit the rear after doing the axle flip? Will the end links mount properly since the leaves are below the axle?
|
just go to a junkyard and get a bronco 2 rear sway bar.....
|
I would think you flipped it(5") and used a 2" chevy drop shakles to make 3" drop just like DJM does...
Anyway...yea...just get a junkyard unit for dirt cheap. and it'll work. Casper98's flipped rear is running a B2 bar. |
Originally Posted by Casper98
(Post 1231850)
just go to a junkyard and get a bronco 2 rear sway bar.....
The wrecking yards around here (very few) are not populated with BII's...I have looked. |
All times are GMT -6. The time now is 07:11 AM. |
© 2024 MH Sub I, LLC dba Internet Brands