Hey was wondering if it were possible to get the edge look on an xlt. Same factory clearance as an edge. This isnt an aftermarket lift just factory clearance like the edge has but without 4x4. I know I can get some axle blocks off an edge at the local junk yard but what about the front end? This would include step bar cortesy of jy edge. Any help would be greatly appreciated.

 

You can't be exact, but yu could get close with coil spacers. An EDGE has torsion bars and sits higher because of that. You Do not.

 

how big would the coil spacers be?

 

Not sure, you'll have to measure your ride height compared to the stock height of an EDGE to figure out the difference.

 

one other question how much of a lift could i do and still use stock shocks?