Front spring Question
 

Ok i have a 97 ranger xlt with the splash suspension on it. Well i replaced all the ball joint and tie rods ends. I also replaced the springs. The front springs uncompressed were 1 and half inches taller then the old ones that were on the truck. My question is; is this goin to hurt anything? and is there factory replacement springs? Around here i couldnt find them and or order them. So any answer would be great guys. come on i need help and i will have pics tomorrow i am uploading some right now before i go to bed.

were did you get the new springs from and maybe the old springs were just sagging and that inch and a half is what height your 97 used to sit at... if thats what your even asking...

i got the springs from advance auto parts and they had to order these in. i dont know i never measured the ride height of the truck cause i just drive it i dont really worry to much about it. and thats kinda what i was askin.

Attachment 178934

here is a side by side of the 2 springs i am workin on a before and after pic

Nothing will happen. You will get a little lift and you may need an alignment but I doubt it. I think you will be all set. And if you do need an alignment it will align easily.

itl go back to stock height probably sit level for once

nice well its been in the shop all day getting an alignment