superlift leaf spring question
#1
superlift leaf spring question
how stiff are the superlift leaf springs compared to the stock leaf springs
my NEW oem replacement leaf springs have sagged so much , now the rear end is 1 inch lower than front end
i like the rear end to sit at least 1.5 inches higher than the front end
the NEW oem leaf springs rebound too easily
also to get rid of the spacer block if i can
i do tow a boat once in a while
my NEW oem replacement leaf springs have sagged so much , now the rear end is 1 inch lower than front end
i like the rear end to sit at least 1.5 inches higher than the front end
the NEW oem leaf springs rebound too easily
also to get rid of the spacer block if i can
i do tow a boat once in a while
#5
#6
yes superlift manufacturers lift leaf springs
#01-193 for the rangers #01-194 for the explorers
i found the info i needed
they are stiff and DO NOT utilize pads between the leave ends which is what i need ( load carrying capacity )
the 01-193 SUPERLIFT ranger leafs have 9 inches of unloaded arch to them
#01-193 for the rangers #01-194 for the explorers
i found the info i needed
they are stiff and DO NOT utilize pads between the leave ends which is what i need ( load carrying capacity )
the 01-193 SUPERLIFT ranger leafs have 9 inches of unloaded arch to them
#7
UPDATE!!!!!
i bit the bullet and purchased the superlift 01-194 ford explorer 3" lift leaf springs
i had them installed yesterday
bye bye spacer blocks , even with the spacer blocks gone these springs still provide 3 inches of rear lift
they would compliment the superlift front end lift kit very well
http://www.summitracing.com/int/parts/slf-01-194
the bushings that are required
http://www.summitracing.com/int/parts/slf-340
and they ride nice and smooth
i will have to crank up my torsion bars again tomorrow morning to compensate
i bit the bullet and purchased the superlift 01-194 ford explorer 3" lift leaf springs
i had them installed yesterday
bye bye spacer blocks , even with the spacer blocks gone these springs still provide 3 inches of rear lift
they would compliment the superlift front end lift kit very well
http://www.summitracing.com/int/parts/slf-01-194
the bushings that are required
http://www.summitracing.com/int/parts/slf-340
and they ride nice and smooth
i will have to crank up my torsion bars again tomorrow morning to compensate
#8
superlift leaf spring question
Originally Posted by cheese_man
UPDATE!!!!!
i will have to crank up my torsion bars again tomorrow morning to compensate
i will have to crank up my torsion bars again tomorrow morning to compensate
Thread
Thread Starter
Forum
Replies
Last Post