just a few questions
#1
just a few questions
im installing new ball joints/ tie rod ends in 2 weeks and while at it i was gona crank my t bars 5-6 turns and install my beltech 6400 shackels. 2 questions.
1. will i have to also install canber adjustemt bolts to get a ligment.
2. can i use either set of holes in the shacket to mount to spring or it has to be furthest out set of holes.
heres some pics for reference
http://www.flickr.com/photos/15556036@N07/2562236795/
http://www.flickr.com/photos/15556036@N07/2563061954/
1. will i have to also install canber adjustemt bolts to get a ligment.
2. can i use either set of holes in the shacket to mount to spring or it has to be furthest out set of holes.
heres some pics for reference
http://www.flickr.com/photos/15556036@N07/2562236795/
http://www.flickr.com/photos/15556036@N07/2563061954/
#3
Member
iTrader: (3)
Join Date: Apr 2008
Location: McHenry,IL
Posts: 586
Likes: 0
Received 0 Likes
on
0 Posts
When you install the new ball joints and tie rod ends you will have to get an alignment and to get it within spec. you will have to get camber eccentric bolts. I just installed some on my truck Carquest Part Number: CCH K80065 $50.00 per side. On the shackles you have to use to 2 holes on the end that are parallel to each other, which ones depends on how much lift you want.I hope this helps.
Jason
Jason
Thread
Thread Starter
Forum
Replies
Last Post
Chopper
General Ford Ranger Discussion
3
02-28-2011 03:54 PM