Ok, so I am going to install a rear sway bar kit...Addco #480 since I found it for $160ish. My question is this...I have done an axle flip (4" on my 7.5" axle) and then installed 1" Belltech F-150 drop shackles to equate to a 3" drop in the rear. Will the Addco kit fit the rear after doing the axle flip? Will the end links mount properly since the leaves are below the axle?

 

just go to a junkyard and get a bronco 2 rear sway bar.....

 

I would think you flipped it(5") and used a 2" chevy drop shakles to make 3" drop just like DJM does...



Anyway...yea...just get a junkyard unit for dirt cheap. and it'll work. Casper98's flipped rear is running a B2 bar.

 

The wrecking yards around here (very few) are not populated with BII's...I have looked.