two question's about a 95 and a 98
#1
two question's about a 95 and a 98
the question for the 94 the 94 is 2wd torsion bar but do you need a special tool to grank them
and for the 98 do you need a bearing press for the front uppers
?????????????????????????????????????????????????? ?????????????????????????????????????????????????? ??????????????????????????????????????????????
thanks for the help
and for the 98 do you need a bearing press for the front uppers
?????????????????????????????????????????????????? ?????????????????????????????????????????????????? ??????????????????????????????????????????????
thanks for the help
#8
What are you talking about? What upper bearing? You talking upper balljoint? You've gotta buy an entire replacement arm w/ joint...you can't replace just the balljoint unless your running Moog upper arms.
#9
Wow. Try typing out full words and full sentences so we can understand what you are asking.
Best I can do is guess at this... The upper balljoints on the 98 ranger do not normally come out of the control arm, you separate the knuckle/spindle from the control arm. There is a pinch bolt on the knuckle. Remove it completely, and hit the bottom of the upper control arm to separate it.
Best I can do is guess at this... The upper balljoints on the 98 ranger do not normally come out of the control arm, you separate the knuckle/spindle from the control arm. There is a pinch bolt on the knuckle. Remove it completely, and hit the bottom of the upper control arm to separate it.
Thread
Thread Starter
Forum
Replies
Last Post
Hillyard
Exterior Semi-Tech
1
03-11-2015 08:04 AM
Tys 4x4 FTW
4.0L OHV & SOHC V6 Tech
11
08-01-2008 01:23 AM