the question for the 94 the 94 is 2wd torsion bar but do you need a special tool to grank them


and for the 98 do you need a bearing press for the front uppers
?????????????????????????????????????????????????? ?????????????????????????????????????????????????? ??????????????????????????????????????????????
thanks for the help

 

there are no 93-97 2wd torsion bar rangers that i know of. 93-97 2wd have twin i-beam with radius arm. no cranking radiums like torsion bars.

 

o ok i thot thay where just old school torsion thanks ill look at them agen cus my plan is to drop this truck on a budget

 

very easy to drop Gen3 rangers! As well as lift them :)

 

thanks for helping so far guys now i just need the help on the 98 its more inportant cus it is my dd

 

any 1

 

i cant figure out what you need to do to the 98

 

What are you talking about? What upper bearing? You talking upper balljoint? You've gotta buy an entire replacement arm w/ joint...you can't replace just the balljoint unless your running Moog upper arms.

 

Wow. Try typing out full words and full sentences so we can understand what you are asking.

Best I can do is guess at this... The upper balljoints on the 98 ranger do not normally come out of the control arm, you separate the knuckle/spindle from the control arm. There is a pinch bolt on the knuckle. Remove it completely, and hit the bottom of the upper control arm to separate it.

 

yea i no i need the hole upper i just need to no if i need a press to put it back in thanks