stabilizer bar bushings
#1
stabilizer bar bushings
wondering how many people have replaced the bushings in there rear sway or stabilizer bar as ford likes. i want to replace mine when i do my springs and frame but not sure of the size. i know i could just go outside and measure but im lazy and figure maybe some one might have some good input or advice.
looks liek choices are 25mm with dual eye end link type or 28.5mm diameter with single eye link type only. and the end link type is where i get confused.
so my question is, which do i have? whats the difference between dual eye and single eye?
looks liek choices are 25mm with dual eye end link type or 28.5mm diameter with single eye link type only. and the end link type is where i get confused.
so my question is, which do i have? whats the difference between dual eye and single eye?
Last edited by Kris03; 02-08-2012 at 03:21 PM.
#5
#7
haha yeaaa about that...i keep having to push back the day i go and pick up the expo leafs cuz **** keeps popping up. but im trying to get it all in one shot since i have to take the bed off to get to the frame part i need to replace i want to have the leafs so its all like pending at this point.
and since im gunna have it all open and apart i figured id replace some bushings
and since im gunna have it all open and apart i figured id replace some bushings
#8
#9
#10
pulled the front bar off of the green one too. endlinks were rusted on when i wanted to replace them so i just cut them with a sawzall and kept it off lol
#12
Thread
Thread Starter
Forum
Replies
Last Post
Liquidswords32
General Technical & Electrical
15
05-17-2011 10:38 AM
Metro55
OLD - Suspension, Tires, & Wheels
8
03-17-2010 12:41 PM