I own a 94 ranger with the manual hubs. I am looking at gettting some alcoa from a guy up the road. I would hate to drive an hour just to find out they don't fit. I am guessing I can't use the caps but would they fit? Thanks

 

The bore in my Alcoas is just under 3". It's too dark outside to get a real accurate measurement but I'd call it about 2 15/16".

 

i can go measure right now the bore. but i know 100% you can not use the front center caps that are supposed to be used...

 

I'm pretty sure they'll work. I have alcoas on my trailer and the bearing caps have to be at least 2.5" in dia. Like everyone else said, you just won't be able to use the wheel caps.

-

 

just a ? for a cheap fix would he be able to cut the center out of the center caps or no. just a ? gaining knowledge

 

no the inside wall tapers down.. manual hubs on the older rangers is kinda large...

 

cool,now i know.