wheel spacers again, 1"
#1
wheel spacers again, 1"
Ok, i know this topic is pretty old, but i didn't see anyone running these on a non-lifted truck. Basically i have some aftermarket rims that are for a 2wd ranger, so my manual locking hubs don't clear the inside by about 3/4 inch. So i am looking at the Eibach 25mm (1 inch) hub centric spacers to bolt over the locking hubs and clear the inside of the rim (summitracing.com $145). The tires are stock diameter, just wider for a street look. The rims are 15x8, 4" backspacing. My truck is a 97 4x4 short box. Anyone see a problem with this? Problems turning at higher speeds? Also on the re-torquing the inner lug nuts, would loctite help? Any insight is greatly appreciated!
#5
back to life with this old thread. finally bought the spacers and have a new problem. the inner hub hole is too small to clear the manual locking hub. the truck has the dana 35 axle. does ANYONE have a 94-97 4x4 with spacers on? looking for nothing wider than 1 1/4 inch. contacted spidertrax, said theirs wont clear either
Thread
Thread Starter
Forum
Replies
Last Post
Want to Trade: Wheel adapters for wheel spacers-OH
andrew_deaton
OLD - Suspension, Tires, & Wheels
2
03-13-2012 08:38 AM
Want to Buy: 1" to 1.5" wheel spacers - IL
theelcaminoman
OLD - Engine & Drivetrain
3
06-17-2011 10:47 AM
Awilliams357m
OLD - Suspension, Tires, & Wheels
5
11-20-2010 03:13 PM
GI_JO_NATHAN
OLD - Suspension, Tires, & Wheels
9
05-03-2010 08:28 AM