Any one use them? Just got a 2011 4x4 and was wondering about these

 

Ive got one inches on the front of mine and their a pain in the *** gives it a good look though

 

How are they a pain?

 

Was thinking of putting 1.5 all the way around.

 

Go for it! I ran them on my F150 lifted on 38's and over 400ftlbs of tq with no issues at all.

Wayne

 

As long as you make sure they're torqued properly you'll be fine. Check them regularly!

 

key is to check them regularly. also the aluminum ones tend to loosen a bit faster than the steel ones.

another thing to consider is the strain the hub bearings get with spacers.... premature wear will be immanent.

 

I had a thread going about them on a stock rim. Do your homework, they might not seat properly if they are hubcentric. You might need lugcentric ones. I haven't really looked so I can't be much more help then that.

 

they will probly be lugcentric

 

Do you have a link to any off hand fhat would benefit me and the op?

 

www.spidertrax.com
MikeR

 

Those were the ones I posted. Someone told me in my thread they were hubcentric and might not fit or seat properly on a stock rim.

 

I need some wheel spacers ... Which spacers for the Jeep will work on a
98 + 2WD Ranger?

 

Anything w/ 5x4.5 I believe.

 

I had the Spidertrax ones front & rear for about a month--looked bad-***, but I ended up sending them back. They REALLY increased my turning radius.
MikeR

 

Not sure about the stock rim fitment, Morris--I had my AR Crushes on at the time.
MikeR