Rims wont go over hub!
#1
#8
#9
They will, i ran them for 3 years with machined out holes
You need to machine that lip on the inside of the rim. I used to run those exact same rims with summer tires. you don't need to take a whole lot out, but that very inner lip is all that needs to go and the hub will fit just fine.
You need to machine that lip on the inside of the rim. I used to run those exact same rims with summer tires. you don't need to take a whole lot out, but that very inner lip is all that needs to go and the hub will fit just fine.
#10
#12
#13
I've machined a set to fit the warn manual hubs, If your trying to do it right, take the truck and rims to a machine shop and let them do it. Or just take measurements and give them to a shop with the rims. I did mine at home, but that was when I had a mill and lathe in the garage.
#15
Just realized the picture I posted is not the rim I have, though it is similar. These are the rims I have... http://i68.photobucket.com/albums/i4...2-12200148.jpg I think the ones I have are from a ford escape.....man I'm so screwed!
#17
Just realized the picture I posted is not the rim I have, though it is similar. These are the rims I have... http://i68.photobucket.com/albums/i4...2-12200148.jpg I think the ones I have are from a ford escape.....man I'm so screwed!
#19
Thread
Thread Starter
Forum
Replies
Last Post
dantheman
General Technical & Electrical
4
08-26-2010 06:33 PM
Want to Buy: ranger rims/b2 rims/exploder rims (ky)
acemavrick
OLD - Suspension, Tires, & Wheels
0
07-11-2010 01:12 PM
1996Ranger4x4SuperCabSTX
OLD - Engine & Drivetrain
4
11-30-2009 09:05 AM
1996Ranger4x4SuperCabSTX
OLD - Engine & Drivetrain
6
11-06-2009 10:46 AM
strictlystangs2
SOHC - 2.3L & 2.5L Lima Engines
7
11-21-2007 09:54 PM