I'm looking to powder coat the wheels on my ranger but I need some placeholders that it can sit on until the wheels are done. Any idea if a 96 f-150 has the same bolt pattern so the ranger would have something to sit on for a few days?

 

No, full size are 5x5.5, Rangers are 5x4.5

 

Hmmm well that's a problem. Not sure how I'm going to do this then. Thanks for the info though.

 

ok so im gonna take of the wheels and leave the ranger on cinder blocks until the wheels are done getting powdercoated....dumb question, is there anywhere specific i need to place the blocks under the truck?

 

I would recommend using jackstands and placing them under the front jack points on each lower control arm.

The rear I would just place them under the axle tube

 

x2
if you're going to use cinder blocks you may as well just let it sit on the ground lol

 

Same for the back? I'm gonna try and do all 4 at the same time but there's a 3 to 4 day turn around time. Wasn't sure if letting it sit on jack stands that long would be an issue.

 

Won't be an issue