Question on JBA Headers
#1
Question on JBA Headers
Hi guys. I am a new member here from GE. I got a quick question for you. I recently installed some JBA headers on my truck and when I was finishing up mounting the exhaust back onto the header, the driver side was really easy and lined up perfectly. The passenger side not so much. In fact, there is now a small exhaust leak and you can hear it as you hit the gas (the leak is very very small, but it is there). I can get a pic of it if you want to better decide the right answer. It sounds like a really bad version of those honda civics with fatty mufflers. My question is how to fix that obviously. I've asked some people around and they either told me I am going to have bend/add more pipe to the exhaust so it fits better or use heat resistance silicone and put it on the outer ring of the valves so when I push them together it fills the gap (which it most likely would since its so small). So now I leave it to you guys...Any other suggestions?
-Ronnie
-Ronnie
#5
contact JBA. Im sure theyde be MORE than helpful in sender you a new header and then you dont have to worry about ruining your headers and bein SOL.
did you do the little dealy where you heat up the engine, then let cool, then tighten then heat up the engine, let cool, tighten a few times?
did you do the little dealy where you heat up the engine, then let cool, then tighten then heat up the engine, let cool, tighten a few times?
Thread
Thread Starter
Forum
Replies
Last Post