Banged up my "94"
#1
Banged up my "94"
Crapola!! Always being particular about my 1994 XLT 4.0 I let my guard down and smacked a concrete light pole base. Dented the hood, bent the bumper and the driver side fender. The hood was pushed back a little and can be re-positioned on the hood brackets. The small dent in the right front of the hood can be straightened. The bumper will have to be replaced along with the driver side fender. Even though my Ranger has 180,000+ miles it runs very good and has been garaged most of its life (I bought it new) so paint should be pretty easy to match. Don't know yet if the bumper brackets will have to be replaced. Will start removal/replacement work Monday.
What years of Ranger parts will interchange with my 94?
What years of Ranger parts will interchange with my 94?
#5
Just completed the repairs on my 94 Ranger. Replaced the left front fender, header panel, both headlight assemblies, left side turn signal assembly and couple of trim pieces.
My question is where do body shops get all the specialized parts to put a vehicle back together? There are these little grips in my 94 header panel that hold in the turn signal assemblies and if they are damaged or lost in an accident where do shops get these replacements when they put a vehicle back together?
My question is where do body shops get all the specialized parts to put a vehicle back together? There are these little grips in my 94 header panel that hold in the turn signal assemblies and if they are damaged or lost in an accident where do shops get these replacements when they put a vehicle back together?
Thread
Thread Starter
Forum
Replies
Last Post
Benjamin08273
SOHC - 2.3L & 2.5L Lima Engines
3
12-17-2014 11:24 AM