Clunking after 2" coil spacers
#1
Clunking after 2" coil spacers
Just installed my 2" coil spacers last week. They went in fine however the order came in with the wrong shocks. No problem..drove in town with no shocks..I listened for any noises and nothing. Put the shocks on..snugged them up properly and now I hear a slight clunk whenever I take off from a start, or turn left or right. What could it be!? I notice that my upper control arm is pointing down a lot more than normal due to the lift. Also there is a slight angle on my tie rods. Is this okay?
I was thinking maybe my sway bar isn't tight enough and could be flexing upon acceleration.
Let me know your guys opinions.
I was thinking maybe my sway bar isn't tight enough and could be flexing upon acceleration.
Let me know your guys opinions.
#2
#7
Same...only when backing out the drive or full turns. Does fab tech make control arms for 2inches of lift? Also..what do you think about it being the sway bar..I know I could just go out and check..but I'm being lazy. I'll prob try tightening it up this weekend.
As far as the ride being stiff..I got some skyjacker nitro 8000s up front and it rides fine. Not a Benz but still great
As far as the ride being stiff..I got some skyjacker nitro 8000s up front and it rides fine. Not a Benz but still great
Thread
Thread Starter
Forum
Replies
Last Post
Want to Buy: Coil spring lift, coil spacers - AL
ubwfuf
OLD - Suspension, Tires, & Wheels
9
03-10-2011 11:27 AM
Awilliams357m
OLD - Suspension, Tires, & Wheels
5
11-20-2010 03:13 PM
GI_JO_NATHAN
OLD - Suspension, Tires, & Wheels
9
05-03-2010 08:28 AM