Keyless Entry Wiring
#1
Keyless Entry Wiring
I am wiring in a Viper 211HV keyless entry system. It appears that the driver and passengers side are seperate. To make both doors open with one button press, can I just join each respective lock and unlock together, or will this cause problems?
I plan on doing this inside the door and routing a wire from there. I cannot locate the wire once it enters the vehicle. If anyone has a trick to locate these wires (pink/yellow and pink/green), or any other pointers for that matter... let me know!
Thanks guys!
PS: 2000 Ranger XLT Supercab w/power locks.
I plan on doing this inside the door and routing a wire from there. I cannot locate the wire once it enters the vehicle. If anyone has a trick to locate these wires (pink/yellow and pink/green), or any other pointers for that matter... let me know!
Thanks guys!
PS: 2000 Ranger XLT Supercab w/power locks.
#2
Figured it out for anyone that may need it.
Viper 211HV
2000 Ford Ranger
Disconnect the battery. Crack open the drivers door, splice into the Pink/Yellow, Pink/Green, and the Black coming from the door lock. Solder, Tape, Tie, and run it through the door jamb (remove the speaker) so that you have a few feet under the steering column of extra wire. Connect the main + from the viper unit (red) to the Yellow wire under the steering column. Run the main viper ground - (black) to a grounded bolt. Pink/Yellow from the door goes to the green/black on the viper unit. Pink/Green (lock) goes to the blue/black on the viper unit. And lastly the black from the door lock goes to the purple/black on the viper unit. Install battery.
Viper 211HV
2000 Ford Ranger
Disconnect the battery. Crack open the drivers door, splice into the Pink/Yellow, Pink/Green, and the Black coming from the door lock. Solder, Tape, Tie, and run it through the door jamb (remove the speaker) so that you have a few feet under the steering column of extra wire. Connect the main + from the viper unit (red) to the Yellow wire under the steering column. Run the main viper ground - (black) to a grounded bolt. Pink/Yellow from the door goes to the green/black on the viper unit. Pink/Green (lock) goes to the blue/black on the viper unit. And lastly the black from the door lock goes to the purple/black on the viper unit. Install battery.
Thread
Thread Starter
Forum
Replies
Last Post
ranger024x4
General Technical & Electrical
10
06-09-2005 07:31 PM
ZetaOmegaRanger
General Technical & Electrical
2
08-08-2004 12:30 AM