blinker question
#2
#4
#5
I did the same thing (99 to 01-03 swap), there is no bulb in the socket, so my blinkers blink twice as fast and it's really annoying. I didn't know if I should just bridge the extra socket terminals or put a resistor in? How much resistance?
also, if you bridged the wires into one socket, it wouldn't make a difference, would it? there would still be the same resistance as if there were 2 sockets and 1 didn't have a bulb, and it would still blink the same.
also, if you bridged the wires into one socket, it wouldn't make a difference, would it? there would still be the same resistance as if there were 2 sockets and 1 didn't have a bulb, and it would still blink the same.
Last edited by TRoyBv6320; 06-15-2008 at 12:32 AM. Reason: addition
#6
Back to your regularly scheduled thread now
Thread
Thread Starter
Forum
Replies
Last Post
gone ballistic
General Technical & Electrical
10
10-04-2005 10:56 PM