LED Fog Light with OEM Switch and Mounting
#1
LED Fog Light with OEM Switch and Mounting
The lenses on my 06 are pretty faded, and instead of cleaning them up I'd like to improve the light output with LED pods.
The 06 bumper has the square fog light holes so I'll look for square pods similar to these.
I would like to use the factory switch, is there anything specific I should do to wire it up that way? I'd hate to have to cut the old bulb out, would prefer something reversible even though I doubt that could happen.
The other challenge is mounting, are there any tips to mounting LED pods in the stock location and hardware?
The 06 bumper has the square fog light holes so I'll look for square pods similar to these.
I would like to use the factory switch, is there anything specific I should do to wire it up that way? I'd hate to have to cut the old bulb out, would prefer something reversible even though I doubt that could happen.
The other challenge is mounting, are there any tips to mounting LED pods in the stock location and hardware?
#2
find out what bulb type are in those fog light housings ( more than likely 9006 )
here is a better kit LED 10,000 lumens stainless steel braided heat sinks
2X CREE LED 80W Headlight Bulbs Xenon White 10000LM Lamp Kit H1 H7 H11 9005 9006 | eBay
no extra wiring needed
here is a better kit LED 10,000 lumens stainless steel braided heat sinks
2X CREE LED 80W Headlight Bulbs Xenon White 10000LM Lamp Kit H1 H7 H11 9005 9006 | eBay
no extra wiring needed
Thread
Thread Starter
Forum
Replies
Last Post
buggman
OLD - Interior, Exterior, Electrical, & Misc.
65
03-24-2014 12:05 AM
buggman
OLD - Interior, Exterior, Electrical, & Misc.
53
03-26-2011 11:27 PM
buggman
OLD - Interior, Exterior, Electrical, & Misc.
8
05-22-2010 05:40 PM
MudSlanger
General Technical & Electrical
5
11-19-2009 12:23 PM
lifted97ranger
General Technical & Electrical
60
03-22-2008 06:11 PM