Noise Filter on 12v Power Point
#1
Join Date: Apr 2008
Location: McHenry,IL
Posts: 586
Likes: 0
Received 0 Likes
on
0 Posts
Noise Filter on 12v Power Point
I found a noise filter that the p/o hooked up to the the 12v power point on my radio bezel. I don't know why it is hooked up and want to get your ideas. It is from radio shack and has supplied power going in, and out back to the power point. Does it serve a good enough purpose to keep? or should I just wire it back to the way it was stock? I was wired in with wire nuts and electrical tape which scare me.
Thanks,
Jason
Thanks,
Jason
#2
Communications?
Do you see any evidence of a CB or Ham radio having been installed in the truck? (ie: holes in dash or on floor) That could be why he had it in there. You sometimes get "alternator whine" in some communications radios - that could be his reason for installing the filter. Just a thought! Disconnect it and see if there's any noise on your stereo equipment - if not, pull it out!
Thread
Thread Starter
Forum
Replies
Last Post
08XLT4x4
General Technical & Electrical
4
04-21-2008 12:28 AM
Ranger1
General Technical & Electrical
14
09-23-2005 12:50 PM