"Line Of Fire" guys - Chime in here...
#1
"Line Of Fire" guys - Chime in here...
So I bought an APC scanning Line of fire. The one thing that makes me scratch my noggin aboug it is that when I have the running lights on and hit the brakes it...
1 goes from 'half bright' to full bright (like it is supposed to, when I hit the pedal)
2 goes out completely, when i release the pedal
3 goes back to 'half bright' about 1/2 a second later...
shouldnt it go from half bright, to full bright, to half bright?
I called the company and thier technical service guy thinks this is related to design, as I am not sure if mine is defective.
Can anyone else let me know how thiers works? Does it go completely out when you release the brakes, and take a 1/2 second or so for the 'half bright' mode to come back on.
Besides that I really like it.
1 goes from 'half bright' to full bright (like it is supposed to, when I hit the pedal)
2 goes out completely, when i release the pedal
3 goes back to 'half bright' about 1/2 a second later...
shouldnt it go from half bright, to full bright, to half bright?
I called the company and thier technical service guy thinks this is related to design, as I am not sure if mine is defective.
Can anyone else let me know how thiers works? Does it go completely out when you release the brakes, and take a 1/2 second or so for the 'half bright' mode to come back on.
Besides that I really like it.
#2
#8
#11
Thread
Thread Starter
Forum
Replies
Last Post
Ace
General Ford Ranger Discussion
29
11-02-2007 03:11 PM
straightedge
General Technical & Electrical
6
01-04-2006 09:23 AM