seat swap
#1
#7
you are swapping only the bottom pan, foam, and cover. the recline handle is attached to the frame, and you would be reusing the driver's frame. so the handle will still be on the outside just as it should. you will have an extra hole in the cover on the inside, but that should get hidden by a console, etc.
#8
Old Guy User…
iTrader: (12)
you are swapping only the bottom pan, foam, and cover. the recline handle is attached to the frame, and you would be reusing the driver's frame. so the handle will still be on the outside just as it should. you will have an extra hole in the cover on the inside, but that should get hidden by a console, etc.
When you bolt in the Driver’s Track/
Slider along with the adjusted all will fit as OEM.
IF you do this, take the back off of the seat first, then the underside track assembly; it will make it a lot easier to to do the change over.
The Seat Covers, although a PITA can e changed out also, time and patients are what is needed.
Thread
Thread Starter
Forum
Replies
Last Post
rngprerunner
Interior, Exterior, & Electrical
19
07-09-2020 07:11 AM
firebirdude
Interior Semi-Tech
13
02-17-2016 01:43 AM
Want to Buy: driver bucket seat and rear seat
cwj
OLD - Interior, Exterior, Electrical, & Misc.
14
09-28-2010 09:02 PM
titanbball2345
Interior Semi-Tech
5
06-18-2008 03:24 PM