New member
#1
New member
My first blog ever!! I hope to receive advice with 2003 Ranger Edge questions. Currently I've replaced upper and lower ball joints and was told I needed a Camber kit for a proper alignment. I looked up Camber kits and have a question about replacing the original bolt parts. The original bolt on the driver side control arm has some lines in the way. Is it possible to get this bolt out without removing the lines?
I'm a novice at working on trucks and a little obsessive about getting things exactly right. Thanks
I'm a novice at working on trucks and a little obsessive about getting things exactly right. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
waterboy
2.9L & 3.0L V6 Tech
10
07-21-2007 05:19 PM