JDM style car key
#1
JDM style car key
Alright guys I found this on another forum called mighty car mods. It's called a JDM key.
FIRST: Buy a screw driver (any size of your preference)
SECOND: Make a copy of your truck/car key.
THIRD: Take a dremel and cut the sides of the key head off and grind it to make it easier to slide in the key
FORTH: Heat up the screw driver in a vise and slide the head of the screw driver off
FIFTH: Put the key in the vise and apply heat and slide the screw driver head down on it.
THE FINISHED PRODUCT
I grinded down the end of the screw driver head and cleaned it up the best I could so it would fit in the ignition.
FIRST: Buy a screw driver (any size of your preference)
SECOND: Make a copy of your truck/car key.
THIRD: Take a dremel and cut the sides of the key head off and grind it to make it easier to slide in the key
FORTH: Heat up the screw driver in a vise and slide the head of the screw driver off
FIFTH: Put the key in the vise and apply heat and slide the screw driver head down on it.
THE FINISHED PRODUCT
I grinded down the end of the screw driver head and cleaned it up the best I could so it would fit in the ignition.
#12
No officer that is my key... I didn't steal it
And if you have more than two keys and can afford to buy another chip key to ruin you could do that for sure.. just cut the chip out of the old key.. drill a hole down the top of the driver and silicone the chip in and cap it.. might be a trial and error effort to get the chip close enough..
older keys is easy.. pop the cap and pull the pill
other options is to tape a chip/key to the column.. but that defeats the purpose of the PATS system and you may as well just use a standard slot screwdriver at that point
And if you have more than two keys and can afford to buy another chip key to ruin you could do that for sure.. just cut the chip out of the old key.. drill a hole down the top of the driver and silicone the chip in and cap it.. might be a trial and error effort to get the chip close enough..
older keys is easy.. pop the cap and pull the pill
other options is to tape a chip/key to the column.. but that defeats the purpose of the PATS system and you may as well just use a standard slot screwdriver at that point
#13
#15
Thread
Thread Starter
Forum
Replies
Last Post
ipMdycguir
General Ford Discussion
7
05-03-2020 08:37 AM
dan4g63
General Technical & Electrical
16
04-24-2011 12:15 PM