2006 B2300 The Silver Bullet
#78
Finally got the beast a much needed wash, spent a good half hour just trying to get the salt off everywhere and in the process found a few spots that I'll have to touch up in summer(Back bumper is starting to rust at the very ends, might just spray the whole thing in bedliner, and inside the rear fenders some paint is starting to chip off so I'll hit that up with bedliner and do the whole section like this-
Anyway, super clean truck!
Then of course the photoshoot after
After seeing this picture I'm really debating about doing a 3" Spindle lift up front with the 2" shackles in the back for a more level look
And my personal favorite
Anyway, super clean truck!
Then of course the photoshoot after
After seeing this picture I'm really debating about doing a 3" Spindle lift up front with the 2" shackles in the back for a more level look
And my personal favorite
#82
#85
Doetsch Spindles not a bad price imo
#86
I know Fabtech used to have some issues in the past with their spindles. Not sure if those have been fixed or not. Crown Suspension makes some as well, but there aren't a lot of guys running them. I think that's mostly due to them just being overlooked. I plan on going with Doetsch when I get a set.
#87
I know Fabtech used to have some issues in the past with their spindles. Not sure if those have been fixed or not. Crown Suspension makes some as well, but there aren't a lot of guys running them. I think that's mostly due to them just being overlooked. I plan on going with Doetsch when I get a set.
#88
Join Date: Apr 2007
Location: Placentia, CA
Posts: 927
Likes: 0
Received 0 Likes
on
0 Posts
#89
Very proud of the silver bullet right now! While I was out cruising with a friend I saw a suv that had slide up onto the curb and had the front end right over the snow bank and onto the sidewalk(about a 3ft snow bank). It was pretty obvious the guy just failed at drifting as you could see the marks through the snow, anyway I hooked on to that giant suburban and managed to pull him out with lots of little jerks(I don't have a hitch and was very scared of pulling from my bumper ball).
Silver Bullet power
And some photo whoring from washing the truck earlier
Silver Bullet power
And some photo whoring from washing the truck earlier
#92
#93
#94
Updates on the truck!
-Getting a class 3 hitch installed next weekend hopefully, no more towing on the bumper
-My tailgate handle broke, went through the car wash and next morning went to open it and bang the handle broke on one side
This is what happens when your friend gets to adventurous
-Getting a class 3 hitch installed next weekend hopefully, no more towing on the bumper
-My tailgate handle broke, went through the car wash and next morning went to open it and bang the handle broke on one side
This is what happens when your friend gets to adventurous
Last edited by UltraHDGames; 02-22-2015 at 10:38 AM.
#95
Coil spacers should be here anyday now, having some issues with ups and fat bobs...
Anyway! On sunday went off roading at seddons corner with a local group, BEST DAY EVER
Not stuck!
I was pretty disappointed I couldn't make it up the hill to actually see this Ranger
Kinda cool, after seddons meet up with an old friend, his truck is little more beast then mine
Anyway! On sunday went off roading at seddons corner with a local group, BEST DAY EVER
Not stuck!
I was pretty disappointed I couldn't make it up the hill to actually see this Ranger
Kinda cool, after seddons meet up with an old friend, his truck is little more beast then mine
#96