2.9L & 3.0L V6 Tech General discussion of 2.9L and 3.0L V6 Ford Ranger engines.

Engine shaking and bucking

Old Feb 22, 2009
  #1  
Shaklakan's Avatar
Thread Starter
|
Member
Joined: Jan 2008
Posts: 1,100
Likes: 0
From: La Habra CA
Engine shaking and bucking

Ok so after being at the desert for awhile my truck is running really ruff. Im not sure why either. I think it could be my misfire getting worse but it just seems to convenient for it to happen while out there. The truck has a really mean shake at anything below 2500 rpm's and it has little to no power but when i gas it and get past 2500 it is fine and runs normal but anytime it dips below 2500 it bucks or shakes. Really wierd. btw its a 92 ranger 3.0 2wd manual if that helps. I need to figure this out before i start commuting again.
 
Reply
Old Feb 22, 2009
  #2  
Jimmeh's Avatar
Member
iTrader: (1)
Joined: Dec 2007
Posts: 3,224
Likes: 1
From: Columbia Falls, MT
My truck was doing the same thing, and once I changed out the MAF sensor, it pretty much stopped. I also had to clean my TPS on the throttle body.
 
Reply
Old Feb 22, 2009
  #3  
mlw20lu's Avatar
Member
iTrader: (2)
Joined: Aug 2008
Posts: 1,825
Likes: 0
From: Loxahatchee, FL
bad spark
 
Reply
Old Feb 22, 2009
  #4  
Shaklakan's Avatar
Thread Starter
|
Member
Joined: Jan 2008
Posts: 1,100
Likes: 0
From: La Habra CA
What can you use the clean the mass air flow sensor again?
 
Reply
Old Feb 22, 2009
  #5  
pacodiablo's Avatar
Member
Joined: May 2004
Posts: 1,126
Likes: 1
From: Charlotte, NC
They sell MAF sensor cleaner at Auto Zone, Advance, and probably even Wal-Mart. Really any store that sells any auto parts should have it. Just spray a few shots on the MAF sensor and you're done. Electronic parts cleaner works well too. Whatever you use must be safe for electrical parts and leave no residue.
 
Reply
Old Feb 22, 2009
  #6  
04blackedge's Avatar
RF Veteran
iTrader: (13)
Joined: Jan 2007
Posts: 23,426
Likes: 8
From: Durham, NC
I would check your plugs and wires as well, mine did the same thing when I had plug wires reversed.
 

Last edited by 04blackedge; Feb 22, 2009 at 07:15 PM.
Reply
Old Feb 22, 2009
  #7  
My91Ranger's Avatar
Member
iTrader: (1)
Joined: Apr 2007
Posts: 2,254
Likes: 5
From: Roseville, Michigan
Sounds like a vacuum leak to me. You may have just ruptured a small line.
 
Reply
Old Feb 22, 2009
  #8  
Shaklakan's Avatar
Thread Starter
|
Member
Joined: Jan 2008
Posts: 1,100
Likes: 0
From: La Habra CA
Nope Nope Nope! Lol its kinda stupid actually. All that bouncing around and jumping and a spark plug wire got pulled off. So i stuck it back on and now it runs like a champ and i cleaned the air filter and maf and now its a lot more responsive thanks guys!
 
Reply
Old Feb 22, 2009
  #9  
04blackedge's Avatar
RF Veteran
iTrader: (13)
Joined: Jan 2007
Posts: 23,426
Likes: 8
From: Durham, NC
I said plug wires lol
 
Reply
Old Feb 23, 2009
  #10  
Prerunner-Ranger's Avatar
Level I Supporter
Joined: Feb 2008
Posts: 2,313
Likes: 4
From: Lancaster, CA.
lol
 
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jccostell
DOHC - 2.3L Duratec / Mazda L Engines
4
Aug 22, 2015 05:17 PM
48bronco
4.0L OHV & SOHC V6 Tech
3
Dec 3, 2014 08:07 AM
cchsbuzz19
4.0L OHV & SOHC V6 Tech
25
Aug 22, 2012 06:01 AM
wolfman00
Drivetrain Tech
21
May 20, 2009 09:16 PM
SouthernMudSlinger
General Ford Ranger Discussion
14
Oct 2, 2006 06:48 AM


Thread Tools
Search this Thread

All times are GMT -6. The time now is 10:05 AM.